Nanoplasty for hair Tyrrel Oxyreduct

Nanoplasty for hair Oxyreduct Turrel is a completely new product for straightening curls. The unique composition, together with innovative technologies, helps to save the result of strand alignment for 11 months! Active elements (honey, rice keratin, amino acids, panthenol) make hair stronger, softer, radiant and reconstruct damaged areas of hair.

Why nanoplasty is worth buying?

• High-quality alignment of curls;
• The composition does not contain hazardous substances;
• The result lasts up to 11 months;
• Provides an adequate level of nutrition and hydration;
• Reconstructs the lipid layer inside the hair;
• Returns health, elasticity, radiance, beauty to strands;
• There is no smoke and smell during the nanoplastic procedure;
• There are no dangerous ingredients in the composition;
• Can be used for damaged curls.

How to use Tyrrel Oxyreduct Moister Keratin Treatment:

1. Moisten your hair with water using a spray bottle.
2. Strands, starting from the occipital area, apply the composition to the hair, retreating from the roots 1-2 cm, distribute the product along the entire length. Use a brush and a fine-toothed comb to apply. Comb each strand 5-7 times until foam appears. (If there is too much foam, then you have applied a lot of composition. Just separate the next strand and, without applying a new portion of the product to it, comb it along with the strand, with excess composition). Apply to all hair.
3. Leave the composition on the hair for 40-60 minutes (depending on the type of hair).
4. WITHOUT using shampoo, rinse your hair under running water. Rinse off approximately 20% of the product. Do not rinse the composition completely!
5. Blot your hair with a towel and dry with a hair dryer and hands, do not use brushes to dry. To dry your hair 100%, divide it into parts and dry it in strands.
6. Argan oil can be applied to dry hair for additional moisture and protection before the straightening step.
7. Divide the hair into 3 parts (one occipital and two temporal) and starting from the occiput, separating strands 1-1.5 cm thick, work through the hair with an iron with titanium or tourmaline plates. Each strand must be pulled at least 15 times at a temperature of 210-230 degrees for healthy, coarse and dense hair and at 180-190 degrees for thin and severely damaged hair.
8. Rinse your hair with any shampoo WITHOUT sulfates and apply any conditioner or hair mask for 2 minutes. Rinse hair under running water, dry with a hair dryer.

Tips:

• Before the procedure, it is recommended to carry out skin allergy tests.
• Always align the roots more and the tips less, thus preventing excessive drying from heat.
• Do a preliminary test on one strand. Wait at least 60 days for a full straightening. For the test strand, repeat.
• The product can “eat” the shade of the hair, it is better to dye the hair after 14 days of the procedure.
• After the procedure, it is recommended to use sulfate-free home care to maintain and prolong the effect.