Nanoplasty for hair Nuance Unique Liss

A one-step product that can turn curls into perfectly even and smooth, also providing them with nutrition and hydration to the very ends.

This product will solve the following problems:

• Strongly curly and hard strands.
• Enhanced fluffiness.
• Strands that are difficult to style.

The basis of this nanoplasty contains hydrolyzed keratin, which is a natural protein that can strengthen each hair and fill voids. It also contains panthenol, lactic acid, natural oils and aloe extract.

How to use:

1. Moisten your hair with water using a spray bottle.
2. Strands, starting from the occipital area, apply the composition to the hair, retreating from the roots 1-2 cm, distribute the product along the entire length. Use a brush and a fine-toothed comb to apply. Comb each strand 5-7 times until foam appears. (If there is too much foam, then you have applied a lot of composition. Just separate the next strand and, without applying a new portion of the product to it, comb it along with the strand, with excess composition). Apply to all hair.
3. Leave the composition on the hair for 40-60 minutes (depending on the type of hair).
4. WITHOUT using shampoo, rinse your hair under running water. Rinse off approximately 20% of the product. Do not rinse the composition completely!
5. Blot your hair with a towel and dry with a hair dryer and hands, do not use brushes to dry. To dry your hair 100%, divide it into parts and dry it in strands.
6. Argan oil can be applied to dry hair for additional moisture and protection before the straightening step.
7. Divide the hair into 3 parts (one occipital and two temporal) and starting from the occiput, separating strands 1-1.5 cm thick, work through the hair with an iron with titanium or tourmaline plates. Each strand must be pulled at least 15 times at a temperature of 210-230 degrees for healthy, coarse and dense hair and at 180-190 degrees for thin and severely damaged hair.
8. Rinse your hair with any shampoo WITHOUT sulfates and apply any conditioner or hair mask for 2 minutes. Rinse hair under running water, dry with a hair dryer.

Tips:

• Before the procedure, it is recommended to carry out skin allergy tests.
• Always iron the roots more and the tips less, thus preventing excessive drying from the heat.
• Do a preliminary test on one strand. Wait at least 60 days for a full straightening. For the test strand, repeat.
• The product can “eat” the shade of the hair, it is better to dye the hair after 14 days of the procedure.
• After the procedure, it is recommended to use sulfate-free home care to maintain and prolong the effect.